================================================================================
UBSAN: Undefined behaviour in drivers/vhost/vhost.c:116:62
load of value 255 is not a valid value for type '_Bool'
CPU: 0 PID: 18901 Comm: syz-executor.2 Not tainted 4.19.152-syzkaller #0
Hardware name: Google Google Compute Engine/Google Compute Engine, BIOS Google 01/01/2011
Call Trace:
 __dump_stack lib/dump_stack.c:77 [inline]
 dump_stack+0x22c/0x33e lib/dump_stack.c:118
 ubsan_epilogue+0xe/0x3a lib/ubsan.c:161
 __ubsan_handle_load_invalid_value.cold+0x63/0x6f lib/ubsan.c:454
 vhost_init_is_le drivers/vhost/vhost.c:116 [inline]
 vhost_reset_is_le drivers/vhost/vhost.c:143 [inline]
 vhost_vq_reset.constprop.0.cold+0x15/0x1a drivers/vhost/vhost.c:325
 vhost_dev_init+0x442/0x780 drivers/vhost/vhost.c:463
 vhost_vsock_dev_open+0x1c9/0x310 drivers/vhost/vsock.c:629
 misc_open+0x372/0x4a0 drivers/char/misc.c:141
 chrdev_open+0x266/0x770 fs/char_dev.c:423
 do_dentry_open+0x4aa/0x1160 fs/open.c:796
 do_last fs/namei.c:3421 [inline]
 path_openat+0x7d5/0x2e90 fs/namei.c:3537
 do_filp_open+0x18c/0x3f0 fs/namei.c:3567
 do_sys_open+0x3b3/0x520 fs/open.c:1085
 do_syscall_64+0xf9/0x670 arch/x86/entry/common.c:293
 entry_SYSCALL_64_after_hwframe+0x49/0xbe
RIP: 0033:0x45de59
Code: 0d b4 fb ff c3 66 2e 0f 1f 84 00 00 00 00 00 66 90 48 89 f8 48 89 f7 48 89 d6 48 89 ca 4d 89 c2 4d 89 c8 4c 8b 4c 24 08 0f 05 <48> 3d 01 f0 ff ff 0f 83 db b3 fb ff c3 66 2e 0f 1f 84 00 00 00 00
RSP: 002b:00007f3e83b32c78 EFLAGS: 00000246 ORIG_RAX: 0000000000000101
RAX: ffffffffffffffda RBX: 0000000000024840 RCX: 000000000045de59
RDX: 0000000000000002 RSI: 0000000020000000 RDI: ffffffffffffff9c
RBP: 000000000118bf68 R08: 0000000000000000 R09: 0000000000000000
R10: 0000000000000000 R11: 0000000000000246 R12: 000000000118bf2c
R13: 00007ffc821feb1f R14: 00007f3e83b339c0 R15: 000000000118bf2c
================================================================================
EXT4-fs (loop0): mounted filesystem without journal. Opts: ,errors=continue
EXT4-fs (loop0): mounted filesystem without journal. Opts: ,errors=continue
EXT4-fs error (device loop0): __ext4_new_inode:922: comm syz-executor.0: reserved inode found cleared - inode=3
omfs: Invalid superblock (0)
omfs: Invalid superblock (0)
EXT4-fs (loop0): mounted filesystem without journal. Opts: ,errors=continue
EXT4-fs error (device loop0): __ext4_new_inode:922: comm syz-executor.0: reserved inode found cleared - inode=3
EXT4-fs (loop0): mounted filesystem without journal. Opts: ,errors=continue
EXT4-fs error (device loop0): __ext4_new_inode:922: comm syz-executor.0: reserved inode found cleared - inode=3
hfs: can't find a HFS filesystem on dev loop4
hfs: can't find a HFS filesystem on dev loop4
batman_adv: batadv0: Interface deactivated: batadv_slave_0
batman_adv: batadv0: Removing interface: batadv_slave_0
batman_adv: batadv0: Interface deactivated: batadv_slave_1
batman_adv: batadv0: Removing interface: batadv_slave_1
device bridge_slave_1 left promiscuous mode
bridge0: port 2(bridge_slave_1) entered disabled state
device bridge_slave_0 left promiscuous mode
bridge0: port 1(bridge_slave_0) entered disabled state
device veth1_macvtap left promiscuous mode
device veth0_macvtap left promiscuous mode
device veth1_vlan left promiscuous mode
device veth0_vlan left promiscuous mode
Bluetooth: hci3: command 0x0409 tx timeout
Bluetooth: hci3: command 0x041b tx timeout
device hsr_slave_1 left promiscuous mode
device hsr_slave_0 left promiscuous mode
team0 (unregistering): Port device team_slave_1 removed
team0 (unregistering): Port device team_slave_0 removed
bond0 (unregistering): Releasing backup interface bond_slave_1
bond0 (unregistering): Releasing backup interface bond_slave_0
bond0 (unregistering): Released all slaves
IPVS: ftp: loaded support on port[0] = 21
chnl_net:caif_netlink_parms(): no params data found
bridge0: port 1(bridge_slave_0) entered blocking state
bridge0: port 1(bridge_slave_0) entered disabled state
device bridge_slave_0 entered promiscuous mode
bridge0: port 2(bridge_slave_1) entered blocking state
bridge0: port 2(bridge_slave_1) entered disabled state
device bridge_slave_1 entered promiscuous mode
bond0: Enslaving bond_slave_0 as an active interface with an up link
bond0: Enslaving bond_slave_1 as an active interface with an up link
IPv6: ADDRCONF(NETDEV_UP): team_slave_0: link is not ready
team0: Port device team_slave_0 added
IPv6: ADDRCONF(NETDEV_UP): team_slave_1: link is not ready
team0: Port device team_slave_1 added
batman_adv: batadv0: Adding interface: batadv_slave_0
batman_adv: batadv0: The MTU of interface batadv_slave_0 is too small (1500) to handle the transport of batman-adv packets. Packets going over this interface will be fragmented on layer2 which could impact the performance. Setting the MTU to 1560 would solve the problem.
batman_adv: batadv0: Not using interface batadv_slave_0 (retrying later): interface not active
batman_adv: batadv0: Adding interface: batadv_slave_1
batman_adv: batadv0: The MTU of interface batadv_slave_1 is too small (1500) to handle the transport of batman-adv packets. Packets going over this interface will be fragmented on layer2 which could impact the performance. Setting the MTU to 1560 would solve the problem.
batman_adv: batadv0: Not using interface batadv_slave_1 (retrying later): interface not active
IPv6: ADDRCONF(NETDEV_UP): bridge_slave_0: link is not ready
IPv6: ADDRCONF(NETDEV_UP): bridge_slave_1: link is not ready
device hsr_slave_0 entered promiscuous mode
device hsr_slave_1 entered promiscuous mode
IPv6: ADDRCONF(NETDEV_UP): hsr_slave_0: link is not ready
IPv6: ADDRCONF(NETDEV_UP): hsr_slave_1: link is not ready
bridge0: port 2(bridge_slave_1) entered blocking state
bridge0: port 2(bridge_slave_1) entered forwarding state
bridge0: port 1(bridge_slave_0) entered blocking state
bridge0: port 1(bridge_slave_0) entered forwarding state
8021q: adding VLAN 0 to HW filter on device bond0
IPv6: ADDRCONF(NETDEV_UP): veth0: link is not ready
IPv6: ADDRCONF(NETDEV_CHANGE): veth0: link becomes ready
bridge0: port 1(bridge_slave_0) entered disabled state
bridge0: port 2(bridge_slave_1) entered disabled state
IPv6: ADDRCONF(NETDEV_UP): team0: link is not ready
8021q: adding VLAN 0 to HW filter on device team0
IPv6: ADDRCONF(NETDEV_CHANGE): bridge_slave_0: link becomes ready
bridge0: port 1(bridge_slave_0) entered blocking state
bridge0: port 1(bridge_slave_0) entered forwarding state
IPv6: ADDRCONF(NETDEV_CHANGE): bridge_slave_1: link becomes ready
bridge0: port 2(bridge_slave_1) entered blocking state
bridge0: port 2(bridge_slave_1) entered forwarding state
hsr0: Slave A (hsr_slave_0) is not up; please bring it up to get a fully working HSR network
hsr0: Slave B (hsr_slave_1) is not up; please bring it up to get a fully working HSR network
IPv6: ADDRCONF(NETDEV_UP): hsr0: link is not ready
IPv6: ADDRCONF(NETDEV_CHANGE): team_slave_0: link becomes ready
IPv6: ADDRCONF(NETDEV_CHANGE): team_slave_1: link becomes ready
IPv6: ADDRCONF(NETDEV_CHANGE): hsr_slave_0: link becomes ready
IPv6: ADDRCONF(NETDEV_CHANGE): hsr_slave_1: link becomes ready
IPv6: ADDRCONF(NETDEV_UP): vxcan0: link is not ready
IPv6: ADDRCONF(NETDEV_CHANGE): hsr0: link becomes ready
IPv6: ADDRCONF(NETDEV_CHANGE): team0: link becomes ready
IPv6: ADDRCONF(NETDEV_UP): vxcan1: link is not ready
IPv6: ADDRCONF(NETDEV_CHANGE): vxcan1: link becomes ready
IPv6: ADDRCONF(NETDEV_CHANGE): vxcan0: link becomes ready
8021q: adding VLAN 0 to HW filter on device batadv0
IPv6: ADDRCONF(NETDEV_UP): veth0_virt_wifi: link is not ready
IPv6: ADDRCONF(NETDEV_UP): veth1_virt_wifi: link is not ready
IPv6: ADDRCONF(NETDEV_CHANGE): veth1_virt_wifi: link becomes ready
IPv6: ADDRCONF(NETDEV_CHANGE): veth0_virt_wifi: link becomes ready
IPv6: ADDRCONF(NETDEV_UP): veth0_vlan: link is not ready
IPv6: ADDRCONF(NETDEV_UP): vlan0: link is not ready
IPv6: ADDRCONF(NETDEV_UP): vlan1: link is not ready
IPv6: ADDRCONF(NETDEV_UP): veth1_vlan: link is not ready
IPv6: ADDRCONF(NETDEV_CHANGE): veth1_vlan: link becomes ready
IPv6: ADDRCONF(NETDEV_CHANGE): veth0_vlan: link becomes ready
device veth0_vlan entered promiscuous mode
IPv6: ADDRCONF(NETDEV_CHANGE): vlan0: link becomes ready
IPv6: ADDRCONF(NETDEV_CHANGE): vlan1: link becomes ready
device veth1_vlan entered promiscuous mode
IPv6: ADDRCONF(NETDEV_UP): macvlan0: link is not ready
IPv6: ADDRCONF(NETDEV_UP): macvlan1: link is not ready
IPv6: ADDRCONF(NETDEV_UP): veth0_macvtap: link is not ready
IPv6: ADDRCONF(NETDEV_UP): veth1_macvtap: link is not ready
IPv6: ADDRCONF(NETDEV_CHANGE): macvlan0: link becomes ready
IPv6: ADDRCONF(NETDEV_CHANGE): macvlan1: link becomes ready
IPv6: ADDRCONF(NETDEV_CHANGE): veth1_macvtap: link becomes ready
IPv6: ADDRCONF(NETDEV_CHANGE): veth0_macvtap: link becomes ready
device veth0_macvtap entered promiscuous mode
IPv6: ADDRCONF(NETDEV_UP): macvtap0: link is not ready
device veth1_macvtap entered promiscuous mode
IPv6: ADDRCONF(NETDEV_UP): macsec0: link is not ready
IPv6: ADDRCONF(NETDEV_UP): veth0_to_batadv: link is not ready
IPv6: ADDRCONF(NETDEV_UP): veth1_to_batadv: link is not ready
batman_adv: The newly added mac address (aa:aa:aa:aa:aa:3d) already exists on: batadv_slave_0