[  143.001306][ T1330] ieee802154 phy0 wpan0: encryption failed: -22
[  143.005802][ T1330] ieee802154 phy1 wpan1: encryption failed: -22
Warning: Permanently added '[localhost]:53589' (ED25519) to the list of known hosts.
qemu-system-x86_64: ahci: PRDT length for NCQ command (0x0) is smaller than the requested size (0xa8000)
[  151.815895][ T1027] ata1.00: Read log 0x10 page 0x00 failed, Emask 0x1
[  151.818819][ T1027] ata1: failed to read log page 10h (errno=-5)
[  151.821623][ T1027] ata1.00: NCQ disabled due to excessive errors
[  151.824397][ T1027] ata1.00: exception Emask 0x1 SAct 0x40000001 SErr 0x0 action 0x0
[  151.847407][ T1027] ata1.00: irq_stat 0x40000000
[  151.855985][ T1027] ata1.00: failed command: WRITE FPDMA QUEUED
[  151.858672][ T1027] ata1.00: cmd 61/90:00:6e:25:05/03:00:00:00:00/40 tag 0 ncq dma 466944 out
[  151.858672][ T1027]          res 50/00:00:00:00:00/00:00:00:00:00/00 Emask 0x1 (device error)
[  151.877107][ T1027] ata1.00: status: { DRDY }
[  151.879673][ T1027] ata1.00: failed command: WRITE FPDMA QUEUED
[  151.885534][ T1027] ata1.00: cmd 61/40:f0:2e:20:05/05:00:00:00:00/40 tag 30 ncq dma 688128 out
[  151.885534][ T1027]          res 50/00:00:00:00:00/00:00:00:00:00/00 Emask 0x1 (device error)
[  151.901181][ T1027] ata1.00: status: { DRDY }
[  151.908848][ T1027] ata1.00: configured for UDMA/100
[  151.914874][ T1027] ata1: EH complete
2026/05/14 08:09:09 parsed 1 programs
[  158.226965][ T5610] Adding 124996k swap on ./swap-file.  Priority:0 extents:1 across:124996k 
[  170.564131][   T51] wlan0: Created IBSS using preconfigured BSSID 50:50:50:50:50:50
[  170.587563][   T51] wlan0: Creating new IBSS network, BSSID 50:50:50:50:50:50
[  172.190996][ T1148] wlan1: Created IBSS using preconfigured BSSID 50:50:50:50:50:50
[  172.201620][ T1148] wlan1: Creating new IBSS network, BSSID 50:50:50:50:50:50
[  174.015565][ T5622] bridge0: port 1(bridge_slave_0) entered blocking state
[  174.048289][ T5622] bridge0: port 1(bridge_slave_0) entered disabled state
[  174.079290][ T5622] bridge_slave_0: entered allmulticast mode
[  174.126238][ T5622] bridge_slave_0: entered promiscuous mode
[  174.148895][ T5622] bridge0: port 2(bridge_slave_1) entered blocking state
[  174.169476][ T5622] bridge0: port 2(bridge_slave_1) entered disabled state
[  174.188342][ T5622] bridge_slave_1: entered allmulticast mode
[  174.215658][ T5622] bridge_slave_1: entered promiscuous mode
[  174.704251][ T5622] bond0: (slave bond_slave_0): Enslaving as an active interface with an up link
[  174.727865][ T5622] bond0: (slave bond_slave_1): Enslaving as an active interface with an up link
[  175.097833][ T5622] team0: Port device team_slave_0 added
[  175.107950][ T5622] team0: Port device team_slave_1 added
[  175.285715][ T5622] batman_adv: batadv0: Adding interface: batadv_slave_0
[  175.303321][ T5622] batman_adv: batadv0: The MTU of interface batadv_slave_0 is too small (1500) to handle the transport of batman-adv packets. Packets going over this interface will be fragmented on layer2 which could impact the performance. Setting the MTU to 1532 would solve the problem.
[  175.352614][ T5622] batman_adv: batadv0: Not using interface batadv_slave_0 (retrying later): interface not active
[  175.392466][ T5622] batman_adv: batadv0: Adding interface: batadv_slave_1
[  175.395737][ T5622] batman_adv: batadv0: The MTU of interface batadv_slave_1 is too small (1500) to handle the transport of batman-adv packets. Packets going over this interface will be fragmented on layer2 which could impact the performance. Setting the MTU to 1532 would solve the problem.
[  175.444170][ T5622] batman_adv: batadv0: Not using interface batadv_slave_1 (retrying later): interface not active
[  175.623030][ T5318] Bluetooth: hci0: unexpected cc 0x0c03 length: 249 > 1
[  175.629065][ T5318] Bluetooth: hci0: unexpected cc 0x1003 length: 249 > 9
[  175.637440][ T5318] Bluetooth: hci0: unexpected cc 0x1001 length: 249 > 9
[  175.641051][ T5318] Bluetooth: hci0: unexpected cc 0x0c23 length: 249 > 4
[  175.645321][ T5318] Bluetooth: hci0: unexpected cc 0x0c38 length: 249 > 2
[  176.608041][ T5622] hsr_slave_0: entered promiscuous mode
[  176.625049][ T5622] hsr_slave_1: entered promiscuous mode
[  177.714776][ T5318] Bluetooth: hci0: command tx timeout
[  178.298720][ T5622] netdevsim netdevsim4 netdevsim0: renamed from eth0
[  178.314147][ T5622] 8021q: adding VLAN 0 to HW filter on device netdevsim0
[  178.326566][ T5622] netdevsim netdevsim4 netdevsim1: renamed from eth1
[  178.359931][ T5622] 8021q: adding VLAN 0 to HW filter on device netdevsim1
[  178.371421][ T5622] netdevsim netdevsim4 netdevsim2: renamed from eth2
[  178.411002][ T5622] 8021q: adding VLAN 0 to HW filter on device netdevsim2
[  178.419685][ T5622] netdevsim netdevsim4 netdevsim3: renamed from eth3
[  178.438511][ T5622] 8021q: adding VLAN 0 to HW filter on device netdevsim3
[  179.079771][ T5622] 8021q: adding VLAN 0 to HW filter on device bond0
[  179.121859][ T5622] 8021q: adding VLAN 0 to HW filter on device team0
[  179.140211][  T146] bridge0: port 1(bridge_slave_0) entered blocking state
[  179.143268][  T146] bridge0: port 1(bridge_slave_0) entered forwarding state
[  179.161748][  T146] bridge0: port 2(bridge_slave_1) entered blocking state
[  179.165047][  T146] bridge0: port 2(bridge_slave_1) entered forwarding state
[  179.794714][ T5318] Bluetooth: hci0: command tx timeout
[  181.112293][ T5622] 8021q: adding VLAN 0 to HW filter on device batadv0
[  181.622917][ T5622] veth0_vlan: entered promiscuous mode
[  181.646602][ T5622] veth1_vlan: entered promiscuous mode
[  181.719506][ T5622] veth0_macvtap: entered promiscuous mode
[  181.741751][ T5622] veth1_macvtap: entered promiscuous mode
[  181.782582][ T5622] batman_adv: batadv0: Interface activated: batadv_slave_0
[  181.819867][ T5622] batman_adv: batadv0: Interface activated: batadv_slave_1
[  181.852816][   T51] netdevsim netdevsim4 netdevsim0: set [1, 0] type 2 family 0 port 6081 - 0
[  181.868003][   T51] netdevsim netdevsim4 netdevsim1: set [1, 0] type 2 family 0 port 6081 - 0
[  181.877204][ T5318] Bluetooth: hci0: command tx timeout
[  181.882847][   T51] netdevsim netdevsim4 netdevsim2: set [1, 0] type 2 family 0 port 6081 - 0
[  181.900643][   T51] netdevsim netdevsim4 netdevsim3: set [1, 0] type 2 family 0 port 6081 - 0
[  183.955079][ T5318] Bluetooth: hci0: command tx timeout
qemu-system-x86_64: hw/ide/core.c:934: ide_dma_cb: Assertion `prep_size >= 0 && prep_size <= n * 512' failed.
Connection to localhost closed by remote host.